Microsens RS232 Specifikace stáhnout pdf (Strana 35)

4 Port Industrial Device Server Manual page 35/36

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

Technical Specification

Type 4 Port Industrial Device Server

Ethernet 2x 10/100Base-T(X) which support Redundant Dual Ether-

net or Switch Mode support. Auto-recover less than 10ms

Ethernet Connector RJ-45

Protection Built-in1.5KV magnetic isolation

Protocols ICMP, IP, TCP, UDP, DHCP, BOOTP, ARP/RARP, DNS, SNMP

MIB II, HTTPS, SSH

Serial Interface 4x RS232 / RS422 / 4(2)-Wire RS485. Which can be

configured by VCOM Manager

Serial Connector Male DB9 / 5 pin terminal block

Serial Baud Rate 110 bps to 460.8 Kbps

Data Bits 5, 6, 7, 8

Parity odd, even, none, mark, space

Stop Bits 1. 1.5, 2

RS-232 signals TxD, RxD, RTS, CTS, DTR, DSR, DCD, RI, GND

RS-422 signals Tx+,Tx-, Rx+, Rx-,GND

RS-485 (4 wire) signals Tx+,Tx-, Rx+, Rx-,GND

RS-485 (2 wire) signals Data+, Data-,GND

Flow Control XON/XOFF, RTS/CTS, DTR/DSR

Serial Line Protection Built-in15KV ESD protection

2KV DC isolation for each port (optional)

LED Indicators PWR P.O.E.(1)(2) / Ready:

1) Red On: Power is on and booting up.

Red Blinking: Indicates an IP conflict, or DHCP or BOOTP

server did not respond properly.

2) Green On: Power is on and functioning normally.

Green Blinking: Located by Administrator.

ETH1(2) Link / ACT:

Amber ON/Blinking: 10 Mbps Ethernet

Green ON/Blinking: 100 Mbps Ethernet

Serial TX / RX LEDS:

Red: Serial port is receiving data

Green: Serial port is transmitting data.

Fault: Fault alarm (Red)

Power Input PWR1/2: 12~48VDC in 6-pin Terminal Block

Reverse Polarity Protection Present at terminal block

Power Consumption 7 Watts MAX

1 2 ... 30 31 32 33 34 35 36

Žádné komentáře

Microsens RS232 Specifikace Strana 35