Microsens RS232 Specifikace stáhnout pdf (Strana 28)

4 Port Industrial Device Server Manual page 28/36

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

Label

Description

Idle Timeout

When serial port stops data transmission for a defined period of time

(Idle Timeout), the connection will be closed and the port will be freed

and try to connect with other hosts. 0 indicate disable this function.

Factory default value is 0. If Multilink is configured, only the first host

connection is effective for this setting.

Alive Check

The serial device will send TCP alive-check package in each defined

time interval (Alive Check) to remote host to check the TCP

connection. If the TCP connection is not alive, the connection will be

closed and the port will be freed. 0 indicate disable this function.

Factory default is 0.

Max Connection

The number of Max connection can support simultaneous connections

are 5, default values is 1.

*Not allowed to mapping Virtual COM from web

Service Mode – TCP Server Mode

In TCP Server Mode, Device Server is configured with a unique Port combination on

a TCP/IP network. In this case, device waits passively to be contacted by the

device. After the device establishes a connection with the serial device, it can then

proceed with data transmission. TCP Server mode also supports up to 5

simultaneous connections, so that multiple device can receive data from the same

serial device at the same time.

The following table describes the labels in this screen.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Žádné komentáře

Microsens RS232 Specifikace Strana 28